PilotEdge Forums

Hi,

I have PTT set up in FSUIPC to work with "Keypad -" and linked to the trigger on a joystick.

"Keypad -" works fine for PTT in P3D; however, the trigger doesn't work.

Never used FSUIPC before - but I think I have it set up right.

Any thoughts?

thanks,
Andrew

That didn't work for me. But mapping the joystick button to 'PTT transmit ON (SB3, RW, AVC) did the trick. I also had to map 'PTT Tansmit OFF (SB3, RW, AVC) to the control sent when the button is released.

Hope this helps.
A

Hi aventura,

Thanks for the help!

That said... what's "(SB3, RW, AVC)" ? Tried digging around in the program and FSUIPC manual(s) but didn't find those references...

[Making some progress - I see it's at least Squawkbox 3 and Advanced Voice Client... ]

cheers
Andrew

SB3 = SquawkBox ver 3
RW = Roger Wilco
AVC = Advanced Voice Client

All are communications addons for network flying such as VATSIM, IVAO, et al.

Don

Thanks Don-

Ok, how did you map "the joystick button to 'PTT transmit ON' " ?

I can't find that!

Thanks again!

Can somebody please clearly explain the procedure.

There are a number of posts on this, but you can check out this thread which explains the procedure:

viewtopic.php?f=14&t=3836

Don

Here's how the FSUIPC setup looks to map to a yoke button.