What is the correct startup and shutdown sequence of P3D and PE? I start P3D first and after it is up and running then I start PE. And when shutting down I close P3D and then PE.
However, everytime while shutting down I get an error message that P3D is not responding and it just hangs up. Just to verify, I un-installed PE and then there were no error messages. When I re-installed PE the error message are back.
Is there any CORRECT sequence for starting and shutting down for these applications? OR is there some other issue?
Pramod
What is the Correct Startup Sequence
Re: What is the Correct Startup Sequence
Pramod,
I generally get the sim up and initially setup, then connect to PE. When shutting down I reverse the order -- disconnect from PE first, then exit out of the sim. No problems with this sequence here.
Don
I generally get the sim up and initially setup, then connect to PE. When shutting down I reverse the order -- disconnect from PE first, then exit out of the sim. No problems with this sequence here.
Don