PilotEdge Forums

What is the correct startup and shutdown sequence of P3D and PE? I start P3D first and after it is up and running then I start PE. And when shutting down I close P3D and then PE.
However, everytime while shutting down I get an error message that P3D is not responding and it just hangs up. Just to verify, I un-installed PE and then there were no error messages. When I re-installed PE the error message are back.

Is there any CORRECT sequence for starting and shutting down for these applications? OR is there some other issue?

Pramod

Pramod,

I generally get the sim up and initially setup, then connect to PE. When shutting down I reverse the order -- disconnect from PE first, then exit out of the sim. No problems with this sequence here.

Don